Show category navigation
Price: 650,00 € netto excl.19% tax
          773,50 € brutto incl. 19% tax
Per Piece fixed price
Count Available 1
Created On: 04.01.2024 15:48
Zuletzt aktualisiert: 03.04.2024 12:45
Condition:
Used



Zum Verkauf steht ein 2-fach Röhren-Kompressor C-1 Dual Valve

Beschreibung

Röhrentyp: The valves are twin triode ECC83 / 12 AX7A types

In just three years, the C-1 Dual Valve Compressor has established itself as an
industry standard dynamics processor. Rather than slavishly imitating designs
of the past, we developed a compressor that combines unrivalled sound quality
with superb flexibility: the C-1 is designed to be used - all the time!
All controls are continuously variable (unlike some other valve units with
switched parameters) and high quality onboard mic pre amps allow direct-totape
recording of microphone sources. Stereo front panel auxiliary inputs mean
a keyboard or guitar can feed straight into the C-1 and down to tape with a
minimum of fuss. Whether the C-1 is tracking vocals and instruments or
adding roundness and warmth to a complete mix, it will become an
indispensable part of your signal path within hours.
The C-1 features a low noise solid state pre amp followed by two valve stages
per channel. The valves are twin triode ECC83 / 12 AX7A types, run from a
stabilised 250v DC power supply. The first valve stage acts as a voltage
amplifier, with the second stage forming part of the gain control element. The
gain control is performed by our own unique transconductance stage which
avoids the use of VCAs - thus improving transparency and minimising
distortion, which is virtually constant at 0.05% over the full bandwidth. The
frequency response of the C-1 is virtually flat between 20Hz and 40kHz, and
measured between -3dB points, the C-1's bandwidth is a staggering 5Hz to
70kHz!
l 2 channels of soft knee, variable ratio compression
l Balanced mic and line level inputs
l Balanced line outputs, switchable for -10dB or +4dB operation
l Unbalanced jack I/O connections
l Stereo front panel auxiliary inputs with gain control and sensitivity
switch (for guitar or keyboards etc.)
l Sidechain insert points for frequency conscious compression
l 48v phantom power
l 90Hz high pass filter switch (12dB / octave). Applies to all inputs
l Continuously variable Input Gain, Threshold, Attack / Release times,
Compression Ratio and Gain Make Up
l Program dependent compression characteristic- attack and release times
automatically adjust in response to program material
l 'Stereo Link' mode - gangs Threshold, Attack, Release and Ratio
controls for processing stereo signal sources
l Illuminated VU meters allow monitoring of either output level or gain
reduction
l Bypass switch with LED
l Frequency response 20Hz to 40kHz +0 / -1dB
SPECIFICATIONS
Mic Input: Impedance: > 10k. Gain range: +16 to +60dB. Input noise (EIN): -
126 dBu (22Hz-22kHz). Max input level: +10dBu. Balanced XLR connector.
Line Input: (Balanced) Impedance: > 5k. Gain range: -10dB to +35dB. Max
input level: +30dBu. XLR connector. (Unbalanced) Impedance: > 5k. Gain
range: -10dB to +35dB. Max input level: +24dBu. Jack connector. Auxiliary
input: Two unbalanced jack connectors for stereo operation, or Input A may be
used to drive both channels. Max input level: +10dBu. Switchable sensitivity
for guitar or keyboards. Output: Balanced output impedance: < 10. Max level:
+22dBu into 600. Unbalanced output impedance: 47. Max level: +20dBu into
10k. Sidechain insert point: stereo jack, tip=send, ring=return. Nominal level -
2dBu. Output impedance: 47, Return input impedance: 10k. Compressor
Functions (all continuously variable):- Threshold: -20dBu to +20dBu. Attack:
0.5mS to 50mS. Release: 40mS to 4S. Ratio: 1:1.5 to 1:30. Gain Make Up:
0dB to +20dB. Frequency response: 20Hz to 40kHz +0 / -1dB. Distortion:
0.05% (10Hz-40kHz). Dynamic Range: 100dB. Power supply: 110-120v or
220-240v AC. Power consumption: 30VA typical. Dimensions: 483 x 205 x
88mm (19" 2U). Weight: 5kg Shipping Weight: 6kg.

Lieferung: ab Lager Nohra-Weimar, Preis versteht sich exclusive Versandkosten

Zahlung: Vorkasse oder bar bei Abholung

Bitte beachten Sie unsere Hinweise zur Datenverarbeitung: https://www.adapoe.de/files/downloads/AGB08.05.07.pdf

Es gelten unsere Allgemeinen Geschäftsbedingungen: https://www.adapoe.de/m2/kontakt/datenschutz.html


adapoe Event- und Studiotechnik OHG
Steinbrüchenstraße 11
DE DE, 99428, Grammetal OT Nohra
Telefon: 03643 811130
E-Mail: thomas@adapoe.de
Webseite: http://www.adapoe.de
View all ads by this user
  Report Fraud
  Tips for safe trading
Print Ad
By contacting via e-mail, your data will be transmitted by you to the provider of this article and stored and processed by the provider for this purpose.


Other ads by this user