Gebrauchte Endstufe Carver PM1201 (Professioneller Amp) 2x600W an 4Ohm (ca. 2x450W an 8 Ohm)
Mono Bridge 1200W an 4 Ohm!
Die Lüfter sind gewöhnungsbedürftig (laut). Ist halt so, bei "alten" Amps.
Dafür sind die Dinger fast nicht umzubringen.
Hinten fehlt der Schaumgummi bei den Lüftern.
Clip Eliminator zuschaltbar.
8-ohm FTC rated power/ch 	450W
4-ohm FTC rated power/ch 	600W
Bridged mono power 	1200W
4/8-ohm FTC rated THD 	0.5%
IM Distortion 	less than 0.1%
Input Impedance (Line) 	15k ohm
Input Sensitivity 	1.5Vrms
Gain 	33dB
Rated full power bandwidth 	+0, -3dB at 3Hz & 80kHz
Slew Rate 	25V/u sec
Power Consumption 	1500 watts
Fusing 	12 amp slo-blo
Damping 	200 at 1kHz
Dimensions (HxWxD inches) 	3.5" x 19" x 12.25" 
Link: 
http://www.carversound.com/carver-amplifiers/pm-1201/
Service: 
https://www.manualslib.com/manual/618107/Carver-Pm-1201.html
Versandkosten innerhalb Europa inklusive! (Kostenloser Versand!)
20% MwSt. ausweisbar!
Der Preis ist Verhandlungsbasis. Bei Selbstabholung geht's deutlich günstiger....  ;-)